Networking.properties

The networking.properties configuration file is used to enable or disable back end servers and configure performance parameters. These settings apply to all the tenants.

The networking.properties file can also be modified manually, after which the server should be shut down and started again.

In case of multiple servers, the networking.properties configurations should be in sync across all the servers.

1. Modifications should be made to the networking.properties files for all servers.
2. Shut down the servers.
3. Start the servers.

The networking.properties file is located in the following directory:

{install_dir}/profiles/LJP/configuration/tomcat/conf/RN

directory

Changing Configuration Parameters

To enable a configuration parameter, remove the Hash mark (#):

config_param (Enabled)

To disable a configuration parameter, add a Hash mark (#):

#config_param (Disabled)

After changing parameters, Restart the Application Server to read the new values.

Warning: Do not change the DBSource property. It's value (RN) is the alias used by the Application Server to connect to the data source. If inadvertently changed, the platform won't run.

Report Scheduler Service

Parameter	Default Setting
report_scheduler_manager_instance report_threads Notes and Usage: If report_scheduler_manager_instance is enabled, then report_threads must also be enabled The report_threads parameter defines the number of threads to be spawned. It can be changed to manage performance. Learn more: Tuning Report Threads	#report_scheduler_manager_instance =1 (Disabled) #report_threads=2 (Disabled, Default = 2)

Import Service

Parameter	Default Setting
import_manager_instance Notes and Usage: In distributed server environments, this parameter should be enabled on a single server, only Learn more: Data Import'	#import_manager_instance = 1 (Disabled)

Export Service

Parameter	Default Setting
export_manager_instance Notes and Usage: In distributed server environments, this parameter should be enabled on a single server, only Learn more: Export Queue	#export_manager_instance = 1 (Disabled)

Memcached Service

Parameter

Default Setting

MemCachedServers=localhost:1121 Notes and Usage: Hostname and Port must match values set at installation Learn more: Installation FAQs Distributed Caching Multiple memcached servers can be used for distributed access, and minimized response time: MemCachedServers=172.28.1.10:11211 172.28.0.120:11211 Notes: The value is space-separated list of server IP addresses and port numbers (11211, in this example) Make sure that all instances are configured the same way, to keep the caches in sync. Learn more: Configuring memcached

#MemCachedServers=localhost:1121 (Disabled)

Bounce Service

Parameter	Default Setting
third_party_marketing_campaign_bounce_processing Learn more: Email Bounce Notification	third_party_marketing_campaign_bounce_processing=1 (Enabled)

One-Click Document Viewing

When enabled, .docx files and PDFs added as attachments appear in a pop-up PDF viewer when clicked. When turned off, only images appear in a popup when clicked. Other documents must be downloaded to be viewed.

Parameter	Notes
<syntaxhighlight lang="apache" enclose="div"> One-Click Document Viewing open_office_enabled=1 open_office_host= open_office_port= </syntaxhighlight>	Requires OpenOffice to be installed on the application server. Learn more: Software Requirements Default OpenOffice port is 8100. Default host is localhost.